CYBEX Arc Trainer 425A Service Manual page 70

B. Position the display console and hand thread
each of the four BHSCS and lockwashers.
See Figure 18.
NOTE: Verify cables are not pinched.
C. Using the 5/32" Allen wrench provided,
tighten the four BHSCS securing the display
console to the console mount.
23. Install monitor
A. Locate monitor (AA), four mounting screws
(DD), four lock washers (EE) and four flat
washers (FF).
B. Remove the back cover from monitor (AA) by
pressing the bottom tabs of the cover in and
rotating out. See Figure 19.
Tab
Tab
NOTE: Press in bottom of tabs and rotate out.
Figure 19
C. Insert the power cable end of (F) through
hole on left side of monitor mount. See
Figure 20.
(AA)
(F)
Power
Cable
(FF)
(EE)
(DD)
Figure 20
(AA)
Back
Cover
Monitor
Bracket
Monitor
Mount
RJ-45
Cable
(F)
Coax
Cable
D. Insert RJ-45 cable and the coax end of (F)
through hole on right side of monitor mount.
See Figure 20.
E. Using a 3 mm Allen wrench secure the
monitor bracket to the monitor mount using
the four mounting screws (DD), four lock
washers (EE) and four flat washers (FF).
See Figure 20.
F. Insert the power cable, coax cable and
RJ-45 cable into the monitor as shown in
Figure 21. NOTE: Use of the CSAFE port is
optional and requires a CSAFE cable and
device.
Power Inlet
12 VDC
(Coax Cable)
Figure 21
G. Secure the power inlet cable to the monitor
plate using the cable tie (P). See Figure 22.
Power Inlet
Cable
Secure Cable
Tie Here
Figure 22
To CSAFE
Device
To Fitness
Antenna/
Equipment
Cable
RJ-45
Source
Monitor
Plate