CYBEX Arc Trainer 425A Service Manual page 49

Kit No. 425AK012
NOTE: This instruction sheet describes how to
replace the top cover in the Arc Trainer 425A.
Tools Required
• Phillips screwdriver
1. Read and understand all instructions
thoroughly before installing this kit.
2. Verify kit contents. See Figure 1.
Top Cover,
425AK012
Figure 1
3. Remove the top cover.
A. Using a Phillips screwdriver, remove the
three screws securing the top cover.
See Figure 2.
Cybex ® and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer ® and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 425A-510 A • March 2008
®
Arc Trainer 425A Top Cover
Figure 2
B. Remove existing top cover.
4. Install new top cover.
A. Place the new top cover in position.
B. Using a Phillips screwdriver, attach the cover
using the three screws removed in step 3A.
C. Tighten screws securely.
5. Test the unit to verify proper operation.
Installation Instructions
Top Cover
Screws
(3)