CYBEX Arc Trainer 425A Service Manual page 47

Arc Trainer
Kit No. 425AK010 (Right Upper Side Cover)
425AK011 (Left Upper Side Cover)
NOTE: This instruction sheet describes how to replace
the upper side cover in the Arc Trainer 425A.
Tools Required
• Phillips screwdriver
1. Read and understand all instructions
thoroughly before installing this kit.
2. Verify you received the appropriate kit.
See Figure 1.
A. 425AK010 Right upper side cover
B. 425AK011 Left upper side cover
A
Figure 1
3. Disconnect the external power source.
A. Unplug the power cord from the power outlet.
! WARNING: Disconnect the power cord before
continuing this procedure. Keep wet
items away from inside parts of the
unit. Electrical shock could occur
even if the unit is unplugged.
®
425A Upper Side Cover
4. Remove the front cover.
A. Using a Phillips screwdriver, remove the
Figure 2
B. Remove front cover.
5. Remove top cover.
A. Using a Phillips screwdriver, remove the
B
Figure 3
B. Remove top cover.
6. Remove upper side cover.
A. Using a Phillips screwdriver, remove the
Installation Instructions
four screws securing the front cover. See
Figure 2.
Front
Cover
Screws
(4)
screw securing the top cover. See Figure 3.
screw securing the upper side cover (A)
or (B). See Figure 4.
Screw