Touchtone Information Display (Putd) - Panasonic KX-TVS120 Installation Manual

7.2.19 Touchtone Information Display (PUTD)

Use the PUTD command to display the touchtones the VPS receives and sends.
In addition to the touchtones, the following will be displayed—the Incoming Call Service
(Voice Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time
periods that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting of this mode for all ports is "OFF".
$ PUTD
Target Port : * * * * * * * * * * * * * * * * * * * * * * * *
Don't leave enabled after troubleshooting.
$
To change the mode from "PUTD" to "OFF", Type PUTD again.
$ PUTD
Target Port : 0000 0000 0000 0000 0000 0000
Don't leave enabled after troubleshooting.
$
Note
"*" means "enable" for the port. "0" means "disable" for the port.
To set the mode for only 1 port, Type PUTD and the port number.
$ PUTD 1
Target Port : 0000 0000 0000 0000 0000 000*
Don't leave enabled after troubleshooting.
$
Installation Manual
SYSTEM MAINTENANCE AND TROUBLESHOOTING
189