Panasonic KX-TVS120 Installation Manual page 107

Voice processing system
Hide thumbs Also See for KX-TVS120:
Table of Contents

Advertisement

The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected.
The PBX is a KX-TD series or KX-TA1232 but
does not have the proper level of software
required to support DPT Integration.
The PBX is not programmed properly to support
DPT Integration.
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven program.
When the System Administrator starts operation, the system asks for the terminal type.
By choosing VT100 [2], all parameters can be set through the menu-driven program.
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number := ______
Please Enter the Number:= [2]
Select [2] because Quick Setup is only available when using a personal computer that
can emulate a VT100 terminal.
11.
Go to the System Administration Top Menu. Select [5] and Press ENTER, or Type [3] then
QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.
TEST: Press the INTERCOM button and then [165]. If the VPS
answers, you have a DPT connection.
Installation Manual
INTEGRATING THE VPS WITH THE PANASONIC KX-T DIGITAL PBX
Table 20
Cause
Remedy
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
107

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tvs320Kx-tvs220

Table of Contents