Panasonic KX-TVS120 Installation Manual page 114

INTEGRATING THE VPS WITH THE PANASONIC KX-T DIGITAL PBX
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "CARD TEST" is displayed on the screen.
• "SYSTEM SETUP" is displayed.
Screen output:
CARD TEST...
SYSTEM SETUP...
1...
11... 12... 13... 14... 15... 16... 17...
• The VPS tests the CPU board, the hard disk drive, and the CO cards
as "SYSTEM SETUP" is displayed.
• Active ports are displayed on the screen (the number of active ports depends on the
VPS model).
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
DPT Interface Connection is Established
Modem Card Initialization Completed
** ON LINE MODE **
Note:
You will see "Modem Card Initialization Completed" only when connecting the KX-
TVS320.
The display will alert you if System Setup is not completed successfully.
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
DPT Interface Connection is not Established
Modem Card Initialization Completed
** OFF LINE MODE **
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
114
2... 3... 4... 5... 6...
13 14 15 16 17 18 19 20 21 22 23 24
13 14 15 16 17 18 19 20 21 22 23 24
7... 8... 9... 10...
Installation Manual