to another port. To reach the VPS, users dial these extension numbers. It is not necessary
to change the default programming for the extensions 165 and 166.
From the SYS-PGM NO ? screen:
a)
Enter [118].
b)
Press the NEXT button (SP-PHONE).
Screen output: VM NO?
c)
Press the NEXT button (SP-PHONE).
Screen output: VM-01:#_ _ -1: 165
( _ _ = the port number you entered in program 117)
d)
Enter the Extension Number that you want this port to have.
(The default extension number for port 1: 165; port 2: 166)
e)
Press STORE.
f)
Repeat steps c, d, and e until all extension numbers are entered.
Conditions:
6.
Connect the jack assigned in Step 4 to the VPS.
7.
Connect your personal computer to the VPS and start your communication software (i.e.,
HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
8.
Turn the power switch off at the VPS and set the DIP/Rotary Switch to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP/Rotary Switch to position 5 will default the Voice Processing System,
resulting in a loss of all user programming and voice messages (except User 1 and User 2
prompts).
9.
Tiurn the power switch back on at the VPS and wait approximately 7-8 min while the
system initializes.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
Installation Manual
INTEGRATING THE VPS WITH THE PANASONIC KX-T DIGITAL PBX
No 2 jacks on the system can have the same extension
number. If you try to enter a number that is already
assigned, you will hear an error tone. Each digital
extension connected provides 2 Voice Mail ports and
must have 2 different extension numbers assigned.
105