7462
High capacity input tray (HCIT) tray lift drive motor assembly removal
Previous
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT cover, right. See
"High capacity input tray (HCIT) cover, right removal" on
page
4-157.
Next
2. Remove the HCIT cover, left. See
"High capacity input tray (HCIT) cover, left removal" on page
4-159.
3. Disconnect the HCIT tray lift drive motor cable connector from the HCIT controller card assembly.
Go Back
Note: Remove the cable from the restraint, and observe the routing for reinstallation.
4. Remove the eight screws (A) securing the HCIT tray lift drive motor assembly.
A
A
5. Remove the HCIT tray lift drive motor assembly.
Repair information
4-163