Media Damage (Using Adf) - Lexmark X651de Service Manual

Media damage (using ADF)

Leading edge
Trailing edge
Step
Properly load document into the ADF unit assembly and
1
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
Check for obstructions in the area of the media feed
2
path in the ADF.
Is the media feed path free from any obstructions?
Is the ADF left cover assembly properly and evenly
3
closed.
Check the ADF/pick roll assembly for damage and
4
wear.
Is the ADF feed/pick roll assembly free from damage
and wear?
Check the ADF separator roll.
5
Is the separator roll free from damage and wear?
Check the ADF controller card assembly.
6
Replace the ADF controller card assembly.
Go to
"ADF controller card removal" on page
Perform a print test using the ADF.
Does the error continue?
Check
4-62.
Yes
Go to step 2. Problem
resolved.
Go to step 3. Remove
obstructions.
Go to step 4. Open then
properly close
the ADF left
cover assembly.
Go to step 5. Replace the ADF
feed/pick roll
assembly.
Go to
"ADF feed
/ pick roll
assembly
removal" on
page 4-56.
Go to step 6. Replace the
separator roll.
Go to
"ADF
separator roll
removal" on
page 4-57.
Replace the Problem
system card resolved.
assembly.
Go to
"System
card assembly
removal" on
page 4-47.
Diagnostic information
7462
Previous
Next
Go Back
No
2-181