Lexmark X651de Service Manual page 158

7462
Check the sensor (ADF media exit) for proper connection.
3
Is the above component properly connected?
Place an undamaged document in the ADF, and perform a
4
ADF test.
Does the error remain?
Perform a print test using the ADF.
5
Does the problem remain?
Sensor (ADF media exit) late jam service check
Use this procedure for the following jams:
• 294.01
Step
Check the original document condition.
1
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes or excessive
wear?
Check the ADF rolls for wear.
2
Is the ADF feed/pick roll assembly or the ADF separation
roll guide assembly free of excess wear?
Service Manual
2-124
Check
Replace the Replace the
sensor (ADF connection.
media exit).
Go to
"Sensor
(standard bin
exit) actuator
assembly
removal" on
or
page 4-86
"Sensor (ADF
media exit)
bracket
assembly
removal (X651)"
on page 4-87
Replace the ADF Problem resolved.
controller card
assembly.
Go to
"ADF
controller card
removal" on
page 4-62.
Go to step 5.
Contact next Problem resolved.
highest level of
tech support.
Yes
Go to step 2. Remove damaged
original document
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to
step 2.
Go to step 3. Clean or replace
the ADF feed/pick
roll assembly or
the ADF
separation roll
assembly.
Go to
"ADF feed /
pick roll
assembly
removal" on
page 4-56
"ADF separator
torque limiter
assembly
removal" on
page 4-58.
Previous
Next
Go Back
No
or