Lexmark X651de Service Manual page 205

Skew
Leading edge
Trailing edge
The printed image is not paralleled with both sides of the media.
Step
Check printer installation placement.
1
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
Properly load media into the media tray assembly and
2
ensure all guides are set correctly.
Properly install the media tray assembly into the printer.
Re-print the defective image.
Does the error continue?
Check for obstructions in the area of the media feed
3
units.
Are the media feed unit assembly free from any
obstructions?
Check the transfer roll assembly for contamination and
4
wear.
Is the above component free of excess wear and
contamination?
Check the alignment assembly for proper adjustment.
5
Go to
"Alignment assembly adjustment" on
page 4-3.
Does the problem remain?
Perform a print test.
6
Does the problem remain?
Check Yes No
Go to step 2. Correct the
installation
placement.
Go to step 3. Problem
resolved.
Go to step 4. Remove
obstructions.
Go to step 5. Replace the
transfer roll
assembly.
Go to
"Transfer
roll assembly
removal" on
page 4-53.
Go to step 6. Replace the
aligner
assembly.
Go to
"Alignment
assembly
removal" on
page 4-21.
Contact next Problem
highest level of resolved.
tech support.
Diagnostic information
7462
Previous
Next
Go Back
2-171