Lexmark X651de Service Manual page 121

Error
code or Error contents
message
922.05 After hot roll lamp
detection, did not roll
over to steady state
control in time.
Fuser type = 1
922.06 Fuser warm-up failure
Fuser type = 1
922.07 Fuser warm-up failure
Fuser type = 1
922.25 Fuser warm-up failure
Fuser type = 2
Description/Action
The control code has gotten
lost (this should really be a
software error.
The fuser hot roll did not reach
operating temperature within
new enhanced control.
The fuser hot roll does not
reach operating temperature
after increasing interpage gap.
The fuser hot roll failed to
reach target departure.
Possible repair actions
Turn the machine off/on.
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Replace the fuser unit
assembly if problem
remains. Go to
"Fuser unit
assembly removal" on
page 4-16.
5. Replace the LVPS card
assembly if problem
remains. Go to
"LVPS card
assembly removal" on
page 4-45.
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Replace the fuser unit
assembly if problem
remains. Go to
"Fuser unit
assembly removal" on
page 4-16.
5. Replace the LVPS card
assembly if problem
remains. Go to
"LVPS card
assembly removal" on
page 4-45.
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Replace the fuser unit
assembly if problem
remains. Go to
"Fuser unit
assembly removal" on
page 4-16.
Diagnostic information
7462
Previous
Next
Go Back
2-87