Setting Prf - JRC JMA-7710-6 Instruction Manual

8.5.3.5 Setting PRF

This function is used to change the repetition frequency to reduce mutual interference.
Whenever the radar interference is not disappeared on the screen by using IR function (subsection "3.2.9
Rejecting Radar Interference"), set PRF according with this section.
1. Press the
Procedures
2. Press the
3. Press the
4. Press the minus (-) side of the
key or
5. Press the
Exit 6. Press the
Note
G This function cannot be used in the plotter mode.
Init set #2
INIT
SET #2
1. BEARING ADJUSTMENT
2. RANGE ADJUSTMENT
3. TUNE ADJUSTMENT
4. SETTING OF PRF
5. PM ADJUSTMENT
6. DATA INPUT FORMAT
7. INITIALIZING GPS MENU (STBY)
8. SETTING DGPS MENU (STBY)
Note
G By pushing the [BRILL] control the pulse repetition frequency is directly changed without opening the
SUB MENU.
SUB
key to open the SUB MENU.
MENU
9
key twice to open the INIT SET #2 menu.
4
key twice to select "SETTING OF PRF".
RANGE
BRILL
control to select number. (0-39)
ENT
key to confirm the setting.
SUB
key.
MENU
23
183 JRC
8 – 30
key or plus (+) side of the
180
8.5
RANGE
0. PREV
9. NEXT
8