Suppressing Sea Clutter [Sea] - JRC JMA-7710-6 Instruction Manual

3.2.4 Suppressing Sea Clutter [SEA]

This control is used to suppress sea clutter. Although turning it clockwise increases the suppressing effect,
excessive suppressing could miss weak target at short range.
To use Auto Suppressing Sea Clutter mode
1. Adjust the
Procedures
Procedures
2. Press the
Select auto suppressing sea clutter mode, then "STC AUTO" appears on upper right of
the screen. Turn the control again when the target is not displayed most clearly.
Exit 3. Press the
Exit
"STC AUTO" disappears on the upper right of the screen, changes to manual mode.
Note
G Auto suppressing sea clutter mode can not select with auto suppressing rain and snow clutter mode.
SEA
AUTO
SEA
AUTO
so that the target is displayed most clearly.
SEA
AUTO
control.
SEA
AUTO
control again.
3 – 6
3.2
3