Modifying Plot; Deleting Plot - JRC JMA-7710-6 Instruction Manual

3.3.23.2

Modifying Plot

Attention
This function is used to delete the display of the specified plot.
Until the plot is cleared and reacquired, the plot immediately before moved to the position to be
cleared is displayed.
1. Press the
Procedures
Procedures
2. Enter the plot No. to be modified using a numeric key (
3. Press the
At this time, the previously-updated status is displayed and "M", standing
for "modification", appears near the mark.
4. Put the cross cursor mark at the position to be modified for reacquisition.
At this time, specify the plot No. input in procedure 2.
ACQ

3.3.23.3 Deleting Plot

Attention
This function is used to delete the display of the specified plot.
The deleted plot cannot be reproduced.
1. Press the
Procedures Procedures
2. Enter the plot No. using a numeric key (
3. Press the
To delete all plots
Keep pressing the
Procedures Procedures
TGT
key.
DATA
CLR
key.
ENT
9
0
, to ,
TGT
key to enable the plot No. to be entered.
DATA
TGT
key to delete the plot with the specified plot No.
CNCL
TGT
key more than 2 seconds.
CNCL
3 – 44
0 to
0 9
to ).
3.3
3
9
).