Transmit/Receive Data Setting (Lan Port Setting) - JRC JMA-5312-6HS Installation Manual

3.21.3 Transmit/Receive Data Setting (LAN Port Setting)

1) Receive Route Data Setting (Route Type)
Set route type.
Note: ECDIS type data and Plotter type data are incompatible.
Route Type set
RADAR :
Plotter :
Never change except following setting. Failure to comply
may result in accidents that would lower performance.
1) Press the [RADAR Menu] key for 2 seconds.
The Code Input menu will appear.
2) Press [5] [3] [0] [0] [1] key.
3) Put the cursor on the ENT button, and press the [ENT] key.
The Utilities menu will appear.
4) Open the Plot menu by performing the following menu operation.
5. Plot
5) Press [3] key, and 3. Route Type set to
2) Transmit Port Setting (TX Setting)
For each sentence, turn on/off transmission.
1) Press and hold [RADAR MENU] key.
The Code Input menu will appear.
2) Press the [0] key, and put the cursor on the
The Serviceman Menu will appear.
3) Open the TX Setting menu by performing the following menu operation.
2. Installation Menu
All manuals and user guides at all-guides.com
Plotter model.
JMA-5300/5200 series
JMA-5300MK2 series (factory default : Plotter )
JLZ-700/900
CAUTION
→ 9. Next
→ 5. LAN Port Setting
→ 1. TX Setting
3-47
ECDIS
ENT button, and press the [ENT] key.