JRC JMA-7710-6 Instruction Manual page 260

8.5
8.5.5.2 Checking DGPS Receiving Status
Checking the DGPS receiving status. When no beacon receiver is connected, or receiver or cable failure
occurs, the message "BEACON RCV NONCONNECT" appears.
• Items
Frequency: Displays the frequency of the beacon station currently received.
Baud rate: Displays the baud rate of the beacon station currently received.
RSSI: Displays the receiving intensity of the beacon station currently received. When it is 100
or lower, the beacon may not be received.
1. Press the
Procedures
2. Press the
3. Press the
4. Press the
Exit
Setting DGPS DGPS Status
SETTING DGPS DGPS STATUS
Press an item number key.
0. PREVIOUS NEMU
1. MODE
2. FREQUENCY
3. BAUD RATE (BPS)
4. SET DATA
5. SEND DATA
6.
7.
8.
9.
STATUS BEACON RCV CONNECT
FREQUENCY
BAUD RATE
RSSI
To close this menu, Press (SUB MENU) key.
SUB
key to open the SUB MENU.
MENU
9
key twice to open the INIT SET #2 menu.
8
key to open the SETTING DGPS DGPS STATUS menu.
SUB
key.
MENU
AUTO MANUAL
xxx. x kHz
50 100 200
1kHz 500Hz
–––––––– kHz
––––– BAUD
–––––
8 – 43