JRC JMA-7710-6 Instruction Manual page 75

Displaying EBL
Procedures
Procedures
The EBL currently selected is displayed in a box on the lower left of the screen.
EBL1
EBL2
EBL1
EBL2
Clearing EBL
EBL
OFF
EBL
OFF
Display of Bearing readout of EBL
Bearing readouts of EBL1 and EBL2 currently shown on the radar display are displayed on the lower left
of the screen.
Also, EBL1 or EBL2 currently activated is displayed in a box on the lower left of the screen.
Motion of EBL
EBL1
• EBL1 is displayed as a line originating from own ship to outer edge of radar display.
• EBL1 rotates in the same direction as the EBL control.
EBL2
• EBL2 is displayed as a line originating from own ship to outer edge of radar display.
• EBL2 rotates in the same direction as the EBL control.
<When EBL2 is used in the floating EBL mode>
EBL2 can be used as a floating EBL.
– Motion of Floating EBL –
• EBL2 is displayed as a line originating from the cursor mark "+" as it moves.
• The originating point moves in the same direction as the trackball.
• EBL2 rotates in the same direction as the EBL control.
• VRM2 on the EBL2 is displayed as a circle.
When EBL2 is changed to the parallel index line, VRM2 is not displayed.
1. Press the
Procedures
Procedures
2. Press the
3. Press the
4. Press the
Exit Exit 5. Press the
Pressing the [EBL1
Pressing it again displays (selects) EBL2.
Pressing the [EBL OFF] switch once clears the EBL outside a box on the
lower left of the screen.
Pressing it again clears the other EBL.
MAIN
key to open the MAIN MENU.
MENU
7
key to select "FLOATING EBL".
7
key to select "OFF" or "ON".
ENT
key.
MAIN
key.
MENU
3 – 16
EBL2] key once displays (selects) EBL1.
3.3
3