JRC JMA-7710-6 Instruction Manual page 94

3.3
To set the cross cursor fixing mode
1. Follow procedures 1 to 3 for setting the cursor length to open the CURSOR
Procedures
Procedures
menu.
2. Press the
3. Press the
4. Press the
Exit 5. Press the
Exit
Motion of Fixed Cursor
In order to fix the cursor, press the
Screen display
2
key to select "FIXED CURSOR".
2
key to select "X/Y AXES", "X AXIS" or "Y AXIS".
ENT
key to confirm the setting.
SUB
key.
MENU
key.
Pressing the key once fixes the cursor in the direction of the axis selected
on the menu.
Pressing it again clears the numerical display of the cursor position.
Pressing it again allows the cursor to move freely.
3 – 35