Pri Timer 1 And Timer 2 Assignment - Panasonic KX-TD1232 Program Manual

General Programming

[463] PRI Timer 1 and Timer 2 Assignment

Description
This PBX employs en-bloc dialing so that dialed digits are not transmitted to the Central Office
until all digits have been entered into the PBX. This assignment selects whether timers and a
counter (PRI Dial Counter) are used to determine end of dialing. If "Effective" is selected,
inter-digit timing is used to determine the end of dialing. If the counter is set to 7 digits
(default), then Timer 1 is used for the first 7 digits of dialing and Timer 2 is used for any digits
dialed after the first 7 digits.
If "Not Effective" is selected, the counter and timers are not used. In this case, the timer
assigned in program [208] Inter Digit Time is used.
This program is only available for the KX-TD1232 with the Primary Rate Interface ISDN
Expansion Unit (KX-TD290).
Selection
• Outside line (CO) number:
KX-TD1232 — 25 through 47,
• Effective / Not Effective
Default
All outside lines — Effective
Programming
1.
Enter 463.
Display: 463 PRI TIMER
2. Press NEXT.
Display: CO Line NO?
3.
Enter an outside line number.
To enter outside line number 25, you can also press NEXT.
Display example: CO25:Effective
4. Keep pressing SELECT until the desired selection is displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or SELECT and the desired
outside line number.
7.
Repeat steps 4 through 6.
8.
Press END.
246
( =all outside lines from 25 to 47)
Programming Guide