General Programming
[139] DID Extension Name Set
Description
Assigns names to the DID extension assigned in program [136] DID Number Assignment.
Selection
• Location number: 001 through 200
• Extension number: 10 characters (max.)
Default
All locations — Not Stored
Programming
1.
Enter 139.
Display: 139 DID NAME
2.
Press NEXT.
Display: Location NO?
3.
Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: 001:Not Stored
4.
Enter a name.
For entering characters, see Section 1.4 Entering Characters.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new name.
5.
Press STORE.
6.
To program another location, press NEXT or PREV, or SELECT and the desired location
number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• A DID extension name is displayed only when the Transfer Table is used.
• You can program the initial display as the DID extension name in Station Programming.
Features Guide References
Direct Inward Dialing (DID)
120
Programming Guide