[220] TIE First / Inter Digit Time
Description
Assigns the maximum time allowed between the start of the dial tone and the first digit dialed
(First Digit Time), and between digits (Inter Digit Time) on a TIE call. If an extension user fails
to dial any digits during this time, the DTMF receiver is released. This timer applies until the
Toll Restriction check is completed.
Selection
Time (seconds): 3 to 30
Default
5 sec
Programming
1.
Enter 220.
Display: 220 TIE TIMER
2.
Press NEXT.
Display example: Time:5 sec
3.
Enter the time.
To change the current entry, press CLEAR and enter the new time.
4.
Press STORE.
5.
Press END.
Conditions
• This timer is used for toll restriction checking.
• You cannot leave the entry empty.
Features Guide References
T1 Line
TIE Line Service
Toll Restriction
Programming Guide
General Programming
145