Did / Tie Incoming Assignment - Panasonic KX-TD1232 Program Manual

General Programming

[431] DID / TIE Incoming Assignment

Description
Assigns a DID / TIE incoming method, immediate or wink, to each DID / TIE format according
to your central office service.
Immediate: Incoming DID and TIE calls can be received right after the receiving signal
arrives.
Wink: Incoming DID and TIE calls can be received after the wink signal is transmitted to the
central office (after the receiving signal arrives).
Selection
• DID / TIE format number:
1 to 8, ( =all DID / TIE formats)
• Immediate / Wink
Default
All DID / TIE formats — Wink
Programming
1.
Enter 431.
Display: 431 SIGNAL IN
2.
Press NEXT.
Display: Format NO?
3.
Enter a DID / TIE format number.
To enter DID / TIE format number 1, you can also press NEXT.
Display example: 1:Wink
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To program another DID / TIE format, press NEXT or PREV, or SELECT and the desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8. Press END.
Conditions
To assign all DID / TIE formats to one selection, press the
display shows the contents programmed for DID / TIE format number 1.
220
key in step 3. In this case, the
Programming Guide