Removal 28 HUMIDITY SENSOR (PL9.1.19)
Steps 1 through 5 are for reference. Before removing this component, check that Steps 1 through 5
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 12)
4)
Remove the LEFT COVER. (Removal 22)
5)
Remove the SHIELD ASSY ESS. (Removal 27)
6)
Release the hook of the SPACER (PL9.1.18), and then remove the HUMIDITY SENSOR from
the printer.
7)
Disengage the connector (P/J261) of the HUMIDITY SENSOR (PL9.1.19).
Version 2 2006.03.31
Chapter 3 Removal and Replacement Procedures (RRPs)
6)-1
3 - 51
6)-2
7)
Kmy03041KA