Main Assembly 2: Ffc, Power Cable, And Plate-Circuit Board Attachment - Epson TM-U950 Technical Manual

CONFIDENTIAL
Main Assembly 2:
1. Insert two FFCs into connectors CN3 and CN4, and then bend the FFCs as in the illustration.
2. Insert the power cable into connector CN1.
3. Mount the plate-circuit board by aligning its indentations with the tabs on the plate-main.
Rev. A
FFC, Power Cable, and Plate-Circuit Board Attachment
Checkpoint
Make sure that the power cable and FFCs are firmly locked into their connectors.
Make sure not to mistake the direction of the FFCs.
CAUTION:
When you disconnect the FFCs from their connectors, be sure to pull them out straight. Otherwise
you may damage the connector pins.
CAUTION:
When unplugging the FFC from the mechanical assembly, pull it straight, and not at an angle.
Pulling it at an angle can damage the pins of the connector.
TM-U950
TM-U950/U950P Technical Manual
TM-U950P
Disassembly, Assembly, and Adjustments 5-71