CONFIDENTIAL
4. Insert the tip of the paper from each roll into the corresponding paper inlet. The paper will
5. Tear off the receipt paper on the paper cutter. If the paper was not fed far enough, press the
6. Press the JOURNAL/SLIP FEED button to feed an additional 30 cm (a foot) or so of journal
7. Insert the tip of the journal paper into the groove on the take-up spool and rotate the spool
Rev. A
automatically be detected and fed into the printer.
Figure 3-4. Inserting Paper into the Paper Inlet
RECEIPT FEED button to feed additional paper.
paper.
two or three times to secure the paper.
Figure 3-5.Inserting the Paper into the Spool
Take-up spool
Groove
TM-U950/U950P Technical Manual
Handling and Maintenance 3-3