Epson TM-U950 Technical Manual page 183

CONFIDENTIAL
Main Assembly 1-5: Attachment of Auto-cutter Unit
1. Place the spring-cutter unit shaft-R onto the shaft of the auto-cutter unit with the short
2. Place the spring-cutter unit shaft-J in the same way.
3. Thread the wiring from the contact pin holder sub-assembly through cutout
4. Thread the wiring from the detector-slip ejection assembly through clasp
5. Thread the cutter motor wiring through cutout
6. Mount the auto-cutter unit on the frame-main sassembly and engage the cutter unit shaft
Connect pin holder sub-assembly wiring
Rev. A
end first.
outside.
protective tubes should not protrude from cutout
springs J and R. Secure it with the RE.
Checkpoint
Make sure that the spring-cutter unit shaft-J is not caught in the detector-slip ejection
assembly wiring.
TM-U950/U950P Technical Manual
and then along groove
c
.
c
Detector-slip ejection assembly wiring
Frame-main assembly
Disassembly, Assembly, and Adjustments 5-45
to the
a
.
b
. The two
d