Epson TM-U950 Technical Manual page 102

CONFIDENTIAL
Procedure for Inserting Personal Check Paper
3. When the personal check paper is detected, the SLIP LED stops flashing and lights steadily.
4. The personal check paper is fed, and the magnetic ink characters on the paper are read and
5. The personal check paper is ejected. Remove it by pulling it upward. Do not pull it out in the
6. The SLIP LED goes out when the personal check paper has been removed.
Printing on personal check paper (when the printer is used with the MICR reader)
Use the following procedure to read MICR characters.
Step User Operation
1
2
3
4
5
6
7
Rev. A
(a) Set the paper so that the side on which the magnetic ink characters have been printed is
facing down, with the characters at the right side of the paper.
(b) Insert the paper until it comes in light contact with the back of the printer. (The paper
should be inserted until the leading edge of the paper reaches the arrow mark on the left of
the printer.)
Figure 3-10. Inserting a Personal Check
printing is carried out on the reverse side of the paper.
horizontal direction. The SLIP LED continues to flash until the paper is removed from the
printer.
Transmit FS a 0 <00>H.
(Transmit DLE ENQ 3.)
Insert a check.
(Transmit FS a 0<00H>.)
Transmit FS a 1.
Transmit endorsement printing data.
Transmit FF.
Eject the check paper.
TM-U950/U950P Technical Manual
Printer Operation
Mechanically switches to MICR mode and waits for a
personal check to be loaded. The SLIP LED blinks.
(When the check waiting state is canceled)
Detects the check, lights the slip LED, and reads MICR
characters. After reading, transmits the reading results.
(Re-reads the check and transmits the reading result.)
Loads the check paper to the print starting position.
Prints data and feeds paper.
After printing, ejects paper. The SLIP LED blinks until the
check is removed.
Switches to two sheet mode. The SLIP LED blinks.
Handling and Maintenance 3-7