CONFIDENTIAL
Sub-assembly H
14. Solder lead wires O and P to the cutter motor terminals.
15. Slide the heat shrink tubes fully onto the terminals and shrink the tubes.
16. Pass the two tubes-protective onto the lead wires.
17. Solder lead wires Q, R, and S to the contact pin holder terminals.
18. Pass lead wires through the protective tube.
19. Dress the lead wires of the detector-slip ejection assembly as shown in the illustration.
Checkpoint
Make sure not to mix up the lead wire colors.
[Adjustment] See auto-cutter blade play adjustment A on page 5-30.
5-16 Disassembly, Assembly, and Adjustments
Contact pin holder sub-assembly
Detector-slip ejection assembly
Rev. A