ADEMCO Vista-10SEa Installation And Setup Manual page 80

VISTA-10SEa Installation and Setup Guide
(Yes) or not
using (No)
Phone Module
Yes
Yes
Yes
Yes
No
No
No
No
If you entered 15 in field 95 to bypass an answering machine, and a 4285/4286 Phone Module is
included in the installation, you should note the following:
When calling in from an off-premises phone (to receive a status report or execute a command),
the user should make the initial call, allow 1 to 3 rings only, hang up, then call in again. The phone
module will now seize the line, and the caller will hear 2 long tones, followed by the usual voice
prompt for the 2-digit phone access code. If this procedure is not followed, phone module
operation will not be possible.
This completes the communication programming.
Exit the Programming mode by keying 99.
Refer to Section 14: TESTING THE SYSTEM to check system operation.
13-6
using (Yes) or are (Yes) or
not using (No) are not (No)
Answering
Machine Downloading
No No
Yes No
No Yes
Yes Yes
No No
Yes No
No Yes
Yes Yes
96 INITIALISE DOWNLOAD ID AND SUBSCRIBER ACCT. NO.
FOR DOWNLOADING
(No data entry required)
...then program Field 95 this way:
Set for value other than 0 (1-14). This
enables control panel to answer phone
call. Otherwise, module cannot be
accessed.
Set for value higher than number of rings
for which answering machine is set.
Example: If machine is set for 4 rings,
program for 5 or higher. Phone module
can still be accessed if answering machine
is turned off and does not answer phone
call.
Set for value other than 0 (1-14).
15 to bypass answering machine. See
note below.
Enter 0.
Enter 0.
Enter 1-14.
Enter 15.