ADEMCO Vista-10SEa Installation And Setup Manual page 41

10 Input Dev: LP #
RF Trans. RF: 1
10 Input Dev: LP#
RF Trans. RF: 1
10 Learn S/N?
0 = No, 1 = Yes 0
10 Input S/N: L
A
X X X–X X X X
10 Input S/N: L
A002-4064 1
If the serial and loop number combination is already present in the system, the keypad will emit a
single long beep. If this happens, the system will not display the serial number, but will wait for a
transmission from another transmitter or transmitter loop input.
formats.)
Press [ ] to continue.
8. Enter the transmitter input device type as follows:
3 = RF (supervised RF transmitter)
4 = UR (unsupervised RF transmitter)
5 = BR (button type RF transmitter - unsupervised)
(Refer to the separate Programming Guide for input
types.)
Press [ ] to continue.
9. The cursor should now be flashing above the loop
number. The default is "1." To accept this, press [ ]. If a
different loop number is being used on this transmitter,
enter the loop number (1–4) and press [ ] to continue
(see the loop designations for various transmitters in the
separate Programming Guide). The loop number must
be entered here, whether you are using Zone
Programming or Sequential Mode to "enroll"
transmitters.
10. If the transmitter's serial number has not been
previously "enrolled," you may enter the enrollment
mode now by either entering "1" (Yes) or by pressing the
upper left-hand button of the "program tool." If you are
using the program tool, move to the physical
location of the transmitter to be enrolled before
pressing the button. A single short beep will verify
that the button has been pressed. The system will
respond to the first serial number transmitted after the
[ ] key on the keypad or the button of the program tool
is pressed.
Enter "0" (No) if you wish to enroll the transmitter
later, using the SEQUENTIAL MODE described in
Section 12.
If you enter "0" (No), go to step 13 (skip steps 11 and 12).
11. This prompt is displayed if you entered "1" (Yes) in
response to the "Learn S/N?" prompt. You may enroll the
serial number by one of two methods:
a. Enter the 7-digit serial number printed on the
transmitter using an alpha keypad.
or
b. Activate the transmitter by faulting or restoring the
input you wish to use for that zone (e.g., press a button,
open or close a door, etc.).
The system will enroll the serial number of the first
transmitter heard, add the loop number entered to this
serial number, display the serial and loop numbers, and
cause the keypad to beep twice.
12. The system will then enter a confirmation mode so that
Section 6: Wireless (RF) Zone Expansion
6-9