ADEMCO Vista-10SEa Installation And Setup Manual page 66

VISTA-10SEa Installation and Setup Guide
Pr ogr am Alpha ?
0 = No, 1 = Yes 00
Cus tom Wor ds ?
0 = No, 1 = Yes 00
Default Descriptor
ZN 01
Flashing Cursor (system
is ready for entry of word).
ZN 01
Flashing Cursor
ZN 01
ZN 01

Flashing Cursor if "6" is
pressed (system is
ready for next word).
ZN 01
D O O R
−
Flashing Cursor
11-2
2. Press 82.
The "Program Alpha?" prompt will appear.
3. Press 1 (Yes).
The "Custom Words?" prompt will appear.
4. Press 0 (No).*
¬
If you did not previously enter a descriptor for zone 1,
the default descriptor for zone 1 will be displayed.
ZO NE 01
* The procedure for adding custom words to the built-in
Note that no entries can be made. Entries can be made
only when the display contains a flashing cursor, which
signifies the Entry mode.
5. To delete or change the default descriptor for zone 1,
press [ ] plus the same zone number (01). This will
¬
clear that descriptor and gain access to the Entry mode
with flashing cursor, allowing changes to be made.
NOTE: If you do not wish to change the existing
6. Press [#] plus the 3-digit number for the first word,
¬
using the "Alpha Vocabulary List" to locate the desired
B ACK
word and its 3-digit number.
Example: The descriptor that we wish to enter for zone
1 is BACK DOOR. From the list, BACK = 013.
Therefore, you would enter [#] 0 1 3.
NOTE: If you accidentally enter the wrong word,
7. Press 6 to accept the selected word and continue.
BACK
NOTE: If this is the only word you are using for the
8. Enter the 3-digit number for the next word. In our
BACK
example, the word is DOOR, whose number is "057."
Enter [#] 0 5 7. The display on the left will appear.
vocabulary is in "Adding Custom Words." later in this
section.
descriptor for zone 1, enter [ ] plus the next
zone number for which you wish to enter (or
check) a descriptor. A summary display for
that zone will appear. You must then press [ ]
plus the same zone number again to gain
access to the Entry mode (flashing cursor) for
that zone.
simply press [#] plus the correct 3-digit
number for the word you want.
descriptor, press 8 instead of 6 to save that
word in memory, and then go to step 11.