Installing The Control; Mounting The Cabinet; Installing The Lock (If Used); Installing The Control's Circuit Board Alone Or (If Used) - ADEMCO Vista-10SEa Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Mounting the Cabinet

Installing the Lock
Installing the Control's Circuit Board Alone or
with a Relay Unit
Installing the Control and RF Receiver Circuit
Boards Together
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Mounting the Cabinet
Mount the control cabinet to a sturdy wall using fasteners or anchors (not supplied), in a
clean, dry area that is not readily accessible to the general public. Four mounting holes are
provided at the back of the cabinet.
If you are using an RF receiver and you intend to mount its PC board within the cabinet,
note the following:
•
Do not mount the cabinet on or near metal objects. This will decrease RF range and/or
block RF transmissions from wireless transmitters.
•
Do not locate the cabinet in an area of high RF interference (revealed by frequent or pro-
longed lighting of the LED in the receiver after it is operational; random flicker is OK).

Installing the Lock (if used)

Use an ADEMCO No. N6277 Cam Lock and No. N6277–1 Push-On Clip (Retainer Clip).
NOTE: The cabinet can be closed and secured without a lock by using 2 screws in the cover's
Figure 2–1. Installing the Lock
edge.
LOCKED
RETAINER
CLIP
UNLOCKED
CABINET DOOR BOTTOM

Installing the Control

Standard Phone Line Connections
Wiring the AC Transformer
Installing the Backup Battery
Earth Ground Connections
1. Remove the cabinet door. It is easily removable
for servicing and is easily re-installed.
2. Remove the lock knockout from the control
cabinet door. Insert the key into the lock.
Position the lock in the hole, making certain
that the latch will make contact with the latch
RETAINER CLIP
(NOTE POSITION)
bracket when the door is closed.
3. Hold the lock steady, and insert the retainer
RETAINER clip into the retainer slots. Position the clip as
SLOTS
illustrated in order to permit easy removal.
NOTE: Before installing the cabinet's contents,
remove the metal cabinet knockouts required for
wiring entry. DO NOT attempt to remove the
knockouts after the circuit board has been
installed.
S E C T I O N 2
2-1