ADEMCO Vista-10SEa Installation And Setup Manual page 72

VISTA-10SEa Installation and Setup Guide
00 Input S/N:
Enter Zn Num.
( 00 = Q uit)
Zone Number Entered
If the zone number entered does not have all of the above attributes, the system will search its
database for the first zone that does, and will display it on the next screen. This means that the
zone number you entered has already been enrolled.
10 Input S/N:
Axxx xxxx
If you do not wish to enroll the zone displayed, press [#] on the keypad or the upper right-
hand button on the program tool (the tool will produce a long beep to verify). The following
prompt will appear:
10 Learn S/N?
0 = No, 1 = Yes
Enter Zn Num.
00 = Quit
Zone Number Entered 
12-2
L
A123-4567 3
10

L
0
12
In this example, the serial number is A123-4567. Once
enrolled, the upper left-hand button of the program tool
can be pressed to ready the system for enrolling a
transmitter into the system.
The serial number for the program tool will remain
in the system only until the Programming mode is
exited. (Entering 97 will not delete the tool.)
Press [ ] to continue.
Pressing [#] on the keypad will cause the system to back up
to the "Program Tool?" prompt.
4. Enter the first zone number to be enrolled (e.g., zone 10).
Press [ ] to continue.
The system will, starting with this zone number, search
for the first transmitter that has all of the following
attributes preprogrammed in Zone Programming:
a. An input type of RF, UR, or BR programmed
b. A loop number programmed
c. No serial number programmed
5. The keypad displays this prompt when the system has
found the next zone that needs to be enrolled.
The system will respond to the first serial number
transmitted. A serial number may be enrolled by one of
two methods:
a. Enter the 7-digit serial number printed on the
transmitter
or
b. Activate the transmitter by faulting or restoring the
input you wish to use for that zone (e.g., press a button,
open or close a door, etc.).
To enroll now, enter 1 (Yes). If you enter 0 (No), the following
prompt will appear if a program tool has already been
programmed:
Enter the next zone number to be enrolled (e.g., zone 12). The
system will search for that zone and will display the prompt
shown in the beginning of step 5. If you wish to exit the Enroll
mode completely, enter 00 and press [ ].