ADEMCO Vista-10SEa Installation And Setup Manual page 15

instructions) into the slots at the top of the cabinet, as shown in Detail A in Figure 2-3.
Make sure that the board rests on the correct row of tabs, as shown.
3. Swing the base of the board into the mounting clips and secure it to the cabinet with the
accompanying screws (see Detail B in Figure 2-3).
4. Insert the top of the control's board into the slot in the clips and position two white clips
at the lower edge of the board (see Detail C).
5. Swing this board into place and secure it with two additional screws.
6. Insert grounding lugs (supplied with the receiver) through the top of the cabinet into the
left-hand terminals of the antenna blocks (at the upper edge of the receiver board) and
secure them to the cabinet top with the screws provided, as shown in Detail D.
7. Insert the receiver's antennas through the top of the cabinet, into the blocks' right-hand
terminals, and tighten the screws.
8. For information about setup and wiring of the receiver, see Section 6: WIRELESS (RF)
ZONE EXPANSION (5800 RF SYSTEMS).
BOARD SUPPORTING SLOTS
RECEIVER CIRCUIT BOARD
(See Detail D)
MEDIUM MOUNTING CLIPS
SCREW
GROUNDING LUG
Figure 2–3. Installing the PC Board and RF Receiver (if used) Together in the Cabinet
HOLES FOR ANTENNAS
AND GROUNDING LUGS
CONTROL
CIRCUIT
BOARD
SHORT MOUNTING CLIPS
ANTENNA
ANTENNA AND
GROUNDING LUG
INSTALLATION
RCVER BRD
CABINET
Section 2: Installing the Control
CIRCUIT
BOARD
CABINET
SIDE VIEW
OF BOARD
SUPPORTING SLOTS
SIDE VIEW OF
MOUNTING CLIPS
DETAIL D
MOUNTING CLIPS
DETAIL A
DETAIL B
MEDIUM
DETAIL C
SIDE VIEW
OF SHORT
2-3