Displaying The Amount Of Media Remaining - Roland VersaUV LEC2-300 User Manual

Managing the Operations Appropriately and Efficiently

Displaying the Amount of Media Remaining

You can display how much of the media in use is left. By setting the amount of media currently remaining at the
start, the amount remaining will be constantly displayed on the screen until it reaches zero.
If you remove the media or cancel media loading by raising the loading lever, the amount remaining at that time
flashes on the screen. Because the amount of media remaining is not updated automatically when you change the
media, redo the setting whenever you change the media. You can also set the machine to display this menu auto-
matically whenever you change the media. See
.
Is Changed(P. 175)
MEMO
The remaining amount that is displayed is only an estimate. Accuracy is not assured.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
SHEET REMAIN
3.
Press [▶], then [▼] to display the screen shown below.
SHEET REMAIN
SET LENGTH
4.
Press [▶] to display the screen shown below.
SET LENGTH
0.0m
5.
Press [▲] or [▼] to set the current amount of media remaining.
SET LENGTH
0.0m
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU] to go back to the original screen.
W 736mm Ｌ 25.0m
• : This display is updated.
• : If media has not been loaded, the set value flashes.
174
3. Optimizing Operation Management
Making Sure to Verify the Setting for the Amount Remaining Every Time the Media
99.9m
25.0m
SETUP SHEET
ROLL L 25.0m