Media Wrinkles; Is The Media Loaded And Set Up Straight And Securely; Was Loaded Media Allowed To Stand For Some Time; Are The Media Clamps Attached - Roland TrueVis AP-640 User Manual

Media Wrinkles

Is the media loaded and set up straight and securely?

Feeding is not smooth when the media is not straight or is tensioned unevenly on the left and right. Reload
the media.
RELATED LINKS
・
P. 27Setup of New Media
・
P. 60Setup of Registered Media

Was loaded media allowed to stand for some time?

Media may shrink or wrinkle if it is heated for an extended time. When printing ends, switch off the sub
power and remove the media.

Are the media clamps attached?

When you are performing printing, be sure to attach the media clamps.

Was the media loaded while the print heater was hot?

Loading media after the print heater has warmed up causes the temperature of the media to rise suddenly,
which may cause the media to shrink or wrinkle during printing. Before loading media, switch off the sub
power and allow the platen to cool.
RELATED LINKS
・
P. 125Adjusting the Ink-drying Method

Is the temperature of the dryer too high?

If the dryer temperature is too high, the media may deform and wrinkle. Set the temperatures to suitable
values for the type of media.
RELATED LINKS
・
P. 125Adjusting the Ink-drying Method

Is [Pullback After Printing] enabled?

Media that has passed once through the dryer may wrinkle depending on its characteristics.
Disable [Media Settings]>[Heater Settings]>[Pullback After Printing] when using media that is prone to
wrinkling caused by the dryer.

Have you stored the media in a low-temperature room?

If the media is loaded while it is still cold, it may wrinkle due to the temperature difference with the print
heater. Before printing, allow the media to come to room temperature.
211
Media Feed Problems