Attaching Printer To Mvs Host S/370 And S/390 Systems; Types Of Installation Covered For Mvs/Jes2; 6400-Lu1-Scs-Local Sna 3174 Control Unit - IBM 6400 Setup Manual

Appendix D

Attaching Printer to MVS Host S/370 and S/390 Systems

Attaching Printer to MVS Host S/370 and S/390 Systems
It is necessary to define a printer in the S/370-S/390 environment to VTAM*,
JES2, POWER, PSF, VPS, JES328X Print Facility, NCP, VM, VSE, MVS,
and/or other software depending upon your operating environment and
printing requirements.
If you are attaching a printer with the IPDS feature installed, review the 6400
IPDS Programmer's Reference Manual for information on configuring IPDS.

Types of Installation covered for MVS/JES2

Below is a list of configurations covered in this appendix:
•
LU1-SCS-Local SNA 3174 Control Unit
•
LU1-SCS-Remote SNA 3174 Control Unit
•
LU3-DSE-Local SNA 3174 Control Unit
•
LU3-DSE Remote SNA 3174 Control Unit
•
LU0-DSC-Local Non-SNA 3174 Control Unit

6400-LU1-SCS-Local SNA 3174 Control Unit

LU1-SCS mode is utilized when neither PSF support nor IPDS is required to
accomplish the print function desired. An existing local 3174 SNA-connected
control unit is assumed. The steps required to install a local LU1-SCS printer
for host definitions are as follows:
1. Define to VTAM by adding logmode entry to VTAM Logmode Table
2. Define to JES2 (Not required but recommended. See the following
details.
3. Define to CICS* or another Application Program such as VPS or
JES328X products.
4. Select the options on the printer that are appropriate for the environment.
Step 1 - VTAM Definition
The following should be added to the Local Major Node VTAM definition. The
printer will be attached as an LU1-IPDS capable printer.
LOC3174V
LOCPU74
LOC6400
LOCADDR=n,MODETAB=MYMODETB,DLOGMODE=6400SCSL,ISTATUS
=ACTIVE
274
BUILD TYPE=LOCAL
PU CUADDR=nnn...
LU