IBM 6400 Setup Manual page 162

Chapter 4
IPDS Feature
Print Language
PRINT LANGUAGE specifies the set of print languages used by the printer.
Refer to the previous page for print language menus.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and
OCR B are the only available values for this parameter. If a different print
quality value is desired, the print language must be changed first.
Undefined Character Substitution (Coax IPDS)
Undefined Character Substitution is accessed under the Coax Interface menu
selection. This configuration value applies only to IPDS on Coax. Undefined
Character Substitution specifies the replacement character to print in place of
any unprintable character that is received by the host.
The character code point can range from hex 40 to hex FE. The factory
default is set to hex 60.
Maximum Printable Width
Maximum Printable Width sets the maximum width of the printer when using a
CT host interface.
•
13.2 inches (the default)
•
13.6 inches
Override Host (Emulation Configuration)
Override Host determines if the operator panel overrides specified IPDS
menu values.
Select one of the following two values:
•
Disable. The default. Does not allow operator panel settings to override
IPDS application commands.
•
Enable. Allows operator panel settings to override IPDS application
commands.
The specified IPDS application commands for the IPDS menu values are:
•
Graphics Quality
•
Bar Code Quality
•
Image Quality
NOTE: No other IPDS menu values or printer operator panels are affected by
162
Override Host. Only the three values listed above are affected.