IBM 6400 Setup Manual page 144

Chapter 4
Ethernet Parameters Menu
Novell Frame
This selection determines which framing scheme will be used in processing
Novell signals.
•
Auto Sensing
•
Ethernet II
•
Ethernet 802.3
•
Ethernet 802.2 (default)
•
802.2 Snap
ASCII Data Port Number
This option sets the port number for ASCII print jobs. The data port number
needs to match your host system setting.
The range is 0 - 65535, and the factory default is 9100.
IPDS Data Port Number
This option sets the port number for IPDS print jobs ranging from
0 - 65536, and the factory default is 5001.
Keep Alive Timer
This is the time that the Keep Alive Timer will run. With the Keep Alive Timer
on, the tcp connection will stay connected even after the print job has
terminated.
The range is 2-10 minutes, and the factory default is 3 minutes.
Ethernet Speed
This menu option only appears if a 10/100Base-T network interface card
(NIC) is installed. The Ethernet Speed menu allows compatibility with different
systems and networks. The factory default is Auto Select.
•
Auto Select. This setting tells the 10/100Base-T NIC to perform an auto
detection scheme and configure itself to be 10 Half Duplex, 10 Full
Duplex, 100 Half Duplex, or 100 Full Duplex.
•
10 Half Duplex. This setting tells the 100 Base-T NIC to communicate at
10 Megabits per second using half duplex.
•
10 Full Duplex. This setting tells the 100 Base-T NIC to communicate at
10 Megabits per second using full duplex.
•
100 Half Duplex. This setting tells the 100 Base-T NIC to communicate at
100 Megabits per second using half duplex.
•
100 Full Duplex. This setting tells the 100 Base-T NIC to communicate at
100 Megabits per second using full duplex.
DHCP
You can enable/disable the DHCP protocol using this option, but consult your
administrator for the appropriate setting.
The options are Disable (the factory default) and Enable.
144