IBM 6400 Setup Manual page 170

Chapter 4
Code V Feature (VGL)
UPC Descenders
This parameter determines if a gap is left for human readable data in UPC/
EAN bar codes, even if there is no human readable data. There will be no
change if there is human readable data.
•
Enable. (the default.) Leaves a gap even if there is no human readable
data.
•
Disable. Does not leave a gap if there is no human readable data.
Rotate Character Size
The Rotated Character Size option determines if rotated (clockwise/counter-
clockwise), expanded characters have a different size than a non-rotated
character with the same size parameters (Adjusted) or the same size (Not
Adjusted).
•
Adjusted. (the default.)
•
Not Adjusted
Ignore Spaces
•
Disable. (the default.) Trailing spaces are NOT deleted from
alphanumeric elements in a graphics pass.
•
Enable. Trailing spaces are deleted from alphanumeric elements in a
graphics pass.
Midline PY
•
Enable. Allows printable characters to precede the ^PY command.
•
Disable. The default. Requires the ^PY command to be the first
characters on a line.
Dark Barcode
•
Disable. (the default.) Bar codes are printed in normal mode.
•
Enable. When enabled, prints all bar codes in a dark mode.
Expanded Font
•
Scalable. (the default.) These expanded characters have rounded edges.
•
Block. These are block characters compatible with the IGP-X00 printers.
LP+ Font
•
Disable. The IGP/VGL uses its default half-dot font, which is slightly
different from the standard bitmap font used by LP+ at 12, 13, 15 and 17
cpi.
•
Enable. The IGP/VGL uses the same font as used by LP+ at all cpi.
170