Removing Shipping Restraints (Pedestal Model) - IBM 6400 Setup Manual

Chapter 2

Removing Shipping Restraints (Pedestal Model)

Removing Shipping Restraints (Pedestal Model)
Protective films and foam blocks protect printer mechanisms from possible
damage during shipment. You must remove these shipping restraints before
you operate the printer.
Save the foam blocks with the other packing materials.
To avoid shipping damage, reinstall the shipping restraints whenever the
printer is moved or shipped. To reinstall the shipping restraints, simply
reverse the steps in this section.
Remove the Protective Film and Envelope
Protective
Film
Figure 17. Removing the Protective Film and Envelope
1. Raise the printer cover.
2. Carefully peel off the tape and lift the protective film off the operator panel
message display.
3. Open the tractor doors.
4. Push the tractor locks down.
5. Slide the tractors outward as far as they will go. The forms thickness lever
should be raised (in the fully open position).
6. Remove the envelope that contains the sample configuration printout.
Store this envelope in a safe place so that you can refer to the
configuration printout.
50
Envelope