IBM 6400 Setup Manual page 116

Chapter 4
Printer Control Menu
When TOP EXIT TEAR mode is selected, the Eject/Restore key operates as
follows:
•
Pressing Eject/Restore causes the paper to advance the bottom of the
last printed form to the tear position, ready for the operator to tear off the
printed forms.
•
Pressing Eject/Restore a second time causes the paper to move into
position such that the top of the first possible form available for printing is
positioned ready for printing. (The direction and amount of paper
movement will depend on the length of the forms; one or more blank
forms will be skipped.)
NOTE: The TOP EXIT TEAR setting is meaningful only on pedestal model
PTR Setup Option
This option selects the Special Function Control Code (SFCC) for the
PTR_SETUP command and functions. The selections for this process are
given below.
•
Setup Parse. This selection is used to enable or disable the PTR Setup
Option. The default is disable.
•
Setup SFCC. Sets the legal hex values from 01 through FF. These
represent the ASCII code (in hexadecimal) of the character used as the
SFCC. The default hex value is 21, which corresponds to the "!"
character.
File System
Provides the means for listing, viewing, and manipulating files in flash
memory. The following selections are available.
•
Overwrite. This selection controls whether the files in flash memory can
be overwritten. With the default selection of Enable, files are overwritten.
If the selection is disabled, the files can not be overwritten.
•
View Files. This selection provides a list of files in flash memory.
Pressing the Scroll ↓ key allows you to view the file size.
•
Delete Files. This selection provides a list of files in flash memory.
Pressing the Enter key will delete the displayed file from flash memory.
•
Optimize & Reboot. Pressing the Enter key with this selection displayed
will reclaim flash memory space and reboot the printer.
IMPORTANT
Do not turn the printer off until it has completed the reboot and is either
Ready or Not Ready.
116
printers. TOP EXIT TEAR cannot be selected on cabinet model
printers.
Forms length must be set correctly for the TOP EXIT TEAR mode to
function properly.