Changing Your As/400 Printer Configuration - IBM 6400 Setup Manual

Appendix D
Attaching Printer to an AS/400 Host System
Follow these steps:
1. Select a printer address from 0 through 6.
2. From the printer operator panel Twinax Interface menu, make sure the
printer address matches the printer address you selected from the table
above. You can select addresses ranging from 0 through 6; the default
address is 1.
3. If the IPDS feature is not installed, you must choose to emulate either a
5225 or 4234-2 printer from the Twinax Interface menu, under Printer
Emulation. The default is 4234-2 printer emulation.
4. If the IPDS feature is installed, you must choose to emulate a 4234-12,
from the IPDS menu, under IPDS Emulation Mode. The default is 4234-
12 printer emulation. See the IPDS Programmer's Reference Manual for
information on the IPDS Emulation Mode values.
5. Turn printer off.
6. Attach the twinax cable from your printer to your host workstation.
7. Turn the printer back on. AS/400's auto configuration program will query
the printer and configure the host system software to recognize the
printer.
8. You may want to execute the AS/400 Workstation Printer (VFYPRT)
Verification Test to make sure the AS/400 host system recognizes the
printer.
NOTE: If you do not want to use the system printer configuration that is

Changing Your AS/400 Printer Configuration

For more information on configuring a printer, see AS/400 Device
Configuration Guide or the online configuration information on the system.
Changing Configuration with Auto Configuration
Auto Configuration can be utilized when either locally or remotely attaching to
the system. The printer is configured as DEVTYPE (4234). Other parameters
are automatically assigned by the system. See the AS/400 Device
Configuration Guide for more information.
270
created by AS/400's auto configuration program, you can change the
printer configuration values as described in the following section.