IBM 6400 Setup Manual page 71

Left Ribbon Spool
Left Ribbon
Pedestal Models
9. Starting from the right ribbon spool, thread the ribbon around the right
ribbon guide, under the right tractor door, between the hammer bank
cover and ribbon mask, and along the ribbon path to the left ribbon guide.
10. Place the empty spool on the left hub.
11. Press the spool down until the hub latch snaps into place.
12. Turn the left spool by hand and check to ensure that the ribbon tracks
correctly in the ribbon path and around the ribbon guides.
NOTE: The 6400-020 printer automatically loads the ribbon when the first
13. Close the forms thickness lever.
Spool
print job is sent.
Setting Rear Paper Exit
Cabinet Models
Forms Thickness
Lever
Forms Thickness
Lever
71