IBM 6400 Setup Manual page 59

3. Connect the customer supplied interface cable from the host computer to
the appropriate printer interface connector (refer to Figure 28 through
Figure 33).
4. Thread the power cable connector up through the notch in the lower-right
back corner of the cabinet (see Figure 32). Plug the power cord into the
printer AC power connector, then into the AC power outlet.
Host Interface
Connectors
I/O Connector
I/O Cover
Cable-Routing
Notches
NOTE:
(1)
The Dataproducts adapter feature attaches to the PC
Parallel interface connector.
(2)
Twinax, Coax, and Ethernet Interfaces appear only if these
features are installed.
Figure 28. Interface and Power Cable Connections - Cabinet Models
Setting Rear Paper Exit
Power
Switch
AC Power
Connector
AC Power
Cable
6ccblcon
59