Dataproducts Menu - IBM 6400 Setup Manual

Chapter 4
Parallel Interface Menu
TOF Action at Prime Signal
TOF (Top–of–Form) ACTION AT PRIME SIGNAL determines whether or not
a form feed is performed before a warm start when the prime signal is
asserted from the host. This setting is only used if PRIME SIGNAL parameter
is enabled.
•
FORM FEED AT RESET (the default)
•
NO FORM FEED AT RESET
Buffer Size in Kilobytes
This parameter determines the size of the input buffer, in 1K increments. Up
to 16K are available. 16K is the default.

Dataproducts Menu

The Dataproducts parallel interface is configured using the following
configuration options.
Dataproducts
(from page 146)
Data Bit 8
Enable* Enable*
Disable Disable
Data Bit 8
The DATA BIT 8 parameter allows access to the extended ASCII character
set. This parameter is enabled by default. When this parameter is disabled,
the printer interprets bit 8 of each incoming data character as a zero,
regardless of its actual setting.
150
PI Data
Ignored Polarity
Standard*
Inverted
Data Request
Strobe
Polarity
Polarity
Standard*
Standard*
Inverted
Inverted
To view options, press:
Scroll Scroll Enter
To select an option, press:
To exit the configuration menus
and return to READY, press:
* = Factory Default
Return
Enter
Start