IBM 6400 Setup Manual page 200

Chapter 4
Printer Emulation Configuration Menu
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A/
OCR B are the only available values for this parameter. If a different print
quality value is desired, the print language must be changed first.
Print Character Table
This parameter prints out a table of the current interface character set.
Print Attributes
The PRINT ATTRIBUTES parameter is used to determine character and
page formatting.
•
PROPORTIONAL SPACING uses proportional spacing for text data when
enabled.
NOTE: Proportional spacing is only supported in 10 CPI. Therefore, you must
•
ITALIC PRINT prints text in italics, when enabled. Both a forward and
backwards slanting italic are available.
•
SLASHED ZERO prints zeros with a slash, when enabled, to distinguish
zeros from the alphabetic capital "O."
•
TEXT POSITION specifies where the text will be positioned in the line
space. When set to Top of Line, text will be positioned at the top of the
line space. When set to Bottom of Line, the text will be positioned as if it
were at the bottom of a 6 lpi line space.
200
DISABLE is the default.
ENABLE uses proportional spacing for text data.
select 10 CPI, or proportional spacing will be ignored.
DISABLE is the default.
FORWARD SLANT uses italic print that slants forward.
BACKWARD SLANT uses italic print that slants backward.
DISABLE is the default.
ENABLE prints zeros with a slash.
BOTTOM OF LINE is the default
TOP OF LINE