SENSORS
CKP SENSOR INSPECTION
The signal rotor is mounted on the generator rotor 1 and CKP
sensor 2 is installed at the inside of the generator cover.
(9-25)
CKP SENSOR REMOVAL AND INSTALLATION
• Remove the generator cover. (3-19)
• Remove the CKP sensor 2.
• Install the CKP sensor in the reverse order of removal.
(3-44)
IAP SENSOR INSPECTION
The IAP sensors 1 are installed under the fuel tank. (4-34)
IAP SENSOR REMOVAL AND INSTALLATION
• Remove the fuel tank. (5-2)
• Disconnect the IAP sensor couplers 2.
• Remove the IAP sensors 1 from the bracket.
• Disconnect the vacuum hoses 3.
• Install the IAP sensors in the reverse order of removal.
TP SENSOR INSPECTION
The TP sensor 1 is installed on the #1 throttle body. (4-38)
TP SENSOR REMOVAL AND INSTALLATION
• Remove the left frame front cover. (8-4)
• Disconnect the TP sensor coupler 2 and remove the TP sen-
sor 1.
09930-11950: Torx
• Install the TP sensor to the throttle body. (5-16)
• Reinstall the removed parts.
• Adjust the TP sensor. (4-19)
• Reset the TP sensor. (5-22)
TPS ADJUSTMENT
• Adjust the TP sensor. (4-19)
R
wrench (T25H)
FI SYSTEM DIAGNOSIS 4-91