Inspection And Disassembly - Suzuki GW250 Service Manual

• Remove the ignition switch D if necessary.

INSPECTION AND DISASSEMBLY

Inspect the removed parts for the following abnormalities.
* Distortion of the steering stem
* Bearing wear or damage
* Abnormal bearing noise
* Race wear or damage
* Dust seal wear or damage
If any abnormal points are found, replace defective parts with
new ones.
• Remove the steering stem lower bearing inner race 1 and
lower seal 2 with a chisel.
• Remove the steering stem upper and lower bearing outer
races using the special tools.
 09941-54911: Bearing outer race remover
09941-74911: Steering race installer
CHASSIS 8-25